Do’s:

1. 1 .Clean condenser during normal service of the car Dirty and clogged condenser results in A/C tripping and less cooling.
2. 2. Maintain proper refrigerant level. Less refrigerant results in less cooling. Excessive refrigerant results in less cooling.
3. 3. Add at least 20 CC of DENSO-6 oil to the compressor during refrigerant charging. Adequate quality of compressor oil prevents poor pumping and premature wearing of internal components.
4. 4. Clean evaporator properly to remove dust and foreign particles. Clogged evaporator results in less air flow and reduced cooling.
5. 5. Adjust fresh air and heater cable properly to close damper’s firmly. Unadjusted cable will result in mixing of hot air with cool air.
6. 6. Refer to the owner’s manual on proper usage of A/C controls. Proper usage of A/C control will give optimum cooling.
7. 7. Check coolant level and ensure proper engine tuning. This will prevent overheating of the engine.
8. 8. Check position of accelerator cut off switch in 1000cc cars. Improper position of accelerator cut off switch will result in tripping.

Dont’s:

1. 1. Do not use A/C with fresh mode open. This will lead to mixing of outside air with cool air inside thereby reducing cooling effect.
2. 2. Do not operate with A/C on. This will result in mixing of hot air with cool air.
3. 3. Do not operate A/C without refrigerant in the system. This will result in premature failure of compressor.
4. 4. Do not leak check the A/C system with more than 20KG/CM2 pressure. Higher pressure may result in damage to A/C components.
5. 5. Do not leave A/C joints open. Moisture tends to enter the A/C system if the joints remain for a long time.
6. 6. Do not leave A/C joints open. Moisture tends to enter the A/C system if the joints remain for a long time.